Solar Wall Light — 3-Sided Glow, 3 LED Spotlight, IPX4, Auto On at Dusk
Solar Wall Light — 3-Sided Glow
A compact solar wall light that charges in daylight and switches itself on at dusk. Three LED lenses — one at the front, one on each side — spread a wide, focused wash across walls, fences and steps, so one fitting lights more surface than a plain downlight. No wiring, no electrician, no running cost.
Highlights
- Three-sided illumination — 3 LED lenses with convex spot optics for a bright centre beam plus side spill
- Monocrystalline 5V panel — keeps charging through overcast weather
- 1800mAh built-in battery — 6–8 hours of light after a 4–6 hour charge in direct sun
- 72LM ±2LM output — warm white 2800–3200K for a soft garden glow
- IPX4 waterproof rating — rain- and snow-resistant housing (manufacturer’s own lab data)
- Light-sensing control — on at dusk, off at dawn; press the button once to arm it
- Wire-free mounting — screws or the 3M adhesive pad, a few minutes per light
Two light colours
- Warm Light — 2800–3200K warm white, the calm default for walls, paths and patios.
- Colorful — RGB output for a decorative wash along fences, gardens and balconies.
Specifications
- Model: YH0628
- Light source: 3 × LED, three-sided arrangement
- Brightness: 72LM ±2LM
- Colour temperature: 2800–3200K (Warm Light); RGB (Colorful)
- Solar panel: monocrystalline silicon, 5V
- Battery: 3.7V / 1800mAh, built-in
- Charging time: 4–6 hours in direct sunlight
- Operating time: 6–8 hours
- Waterproof rating: IPX4 (data sourced from the manufacturer’s own lab)
- Material: ABS + PMMA
- Colour: black
- Unit size: 14.2 × 8.9 × 9.5 cm
- Inner box: 15.4 × 11 × 6.7 cm, 0.2 kg
- Mounting: wall-mounted, drill or adhesive
- Control: light sensor with ON/OFF push button
How it works
The panel absorbs daylight and stores the energy in the built-in battery; the light sensor then switches the LEDs on at dusk and off at dawn. Mount it where the panel faces direct sun — shaded or indoor positions stop the battery charging and the light will not run. This is a solar charging limitation, not a fault.
Mounting
Drill mount: mark the bracket with the positioning card, drill, fix with the supplied screws and expansion bolts, then hang the light. Adhesive mount: arm the switch, apply the 3M pad to a clean flat surface and press the light on. Both take a few minutes and need no wiring.
What’s in the box
1 × solar wall light, screws and expansion bolts, positioning card, instruction manual.